N400 High Speed Tonnage Monitor

N400 Series High Speed Tonnage Monitor

N400 Series High Speed Tonnage Monitor

The N400 Series was designed specifically for high speed applications, canning operations, compaction presses and refractory presses. High and low limits can be manually adjusted with the N400. Thus, the operator can set the tolerance very precisely, which is ideal for high speed presses.

It is typically used with sensors and load cells for point-of-operation monitoring. The combination of monitoring and the fact that the N400 uses actual tonnage numbers for high and low limits (compared to benchmark systems), is important for this type of production. The N400 allows you to have precise control of your press.



Features

  Standard Option
Displays left & right tonnage  
Total working press tonnage  
Manual high & low tonnage limits  
Displays high & low tonnage alarm limits  
Identifies over or under tonnage
  conditions
 
Built-in alarm relay to stop the press  
Easily modified for 24 volt usage  
Resolution is .05% of full scale  
Overload protection at all times  
One, two or four sensor inputs  
Analog output jacks  
Automatic zero balance  
Helps predict a possible problem  
Preset counter 0-9  
Reverse load display  
Flushmount  
Sensors for Bruderer presses  

Specifications

   
No. Of Channels One, Two or Four
Sensor Inputs Full bridge strain gauge sensors
120 to 1000 ohms
Up to (4) 350 ohm sensors
Sensor Excitation Built-in 5VDC @ 125mA max (Short circuit protected)
Balance Range +/- 1mV/V of offset
Gain Range Low Gain = 0.568mV/V to 5.000mV/V
High Gain = 0.057mV/V to 0.625mV/V
Analog Output .25" stereo phono jack
2.5VDC @ Press Capacity
Accuracy +/- 1% of full scale max
Non-linearity +/- .1% of full scale max
Frequency
  Response
Flat DC to 1KHz
Display 4 digit display
Display Update Every Stroke (up to 2 updates per second max)
Resolution 1024 count
SPM 400 SPM (threshold trigger)
2000 SPM (probe trigger)
Calibration Shunts 768k Ohm .1% precision resistor
Computer
  Interface
No
Trigger Probe or Threshold
Threshold Probe Built-in voltage source provides power for N.O. PNP proximity probes. Also supports limit switch, solid state or mechanical relays
Resolver Interface No
Shutdown Relay 10A @ 120VAC
N.O. Contact
Bypass switch available
Power Req. 32 Watts max, 95-130VAC @ 50-60Hz OR
190-260VAC @ 50-60Hz
Operating Temp. 0-70 degrees Celsius
Weight Approximately 21.3lbs

  Width Height Depth
Dimensions 12.5 " 14.5 " 6.8 "

Manual/Downloads

Name Format Link
User Manual PDF

Accessories/Related

Type Name Description Link
Standard Product PM Kit PM Kit includes strain gauge
  sensors, cables and mounting
  hardware
Service Installation On-site product installation

Contact





Enter the value below to validate the form:
CAPTCHA Image
[ Different Image ]